Jack ZB-A4F - Page 10

10 / 14
4
：
Descending
accounting to 0, alarm and
stop running
5： Ascending accounting to full, remind and
keep running
6： Descending accounting to 0, alarm and
keep running
Note: press P shortly to cancel alarm
P91 Stitch count value
0 0-9999
P92 Piece count value
0 0-9999
P93 Voice switch
1 0-1
0： Off 1： On
P94 Boot language switch
1 0-1
0： Off 1： On
P95 Language selection
0 0-1
0： Chinese 1： English
P97 Main part stitch length
35 0-50
P98
Condense stitch mode selection
0 0-3
0-Close
1-Front encryption 2-Back encryption
3-Front and back encryption
P99 Stitch Lock
0 0-1
0： Off 1： On
P100
Manual inverted seam switchin
g speed limit function selection
0 0-1
0： Off 1： On
P101
1/2 stitch length key mode
change EN
0 0-1
0： Off 1： On
P107
Safety needle break selection
switch
1 0-1
0： Off 1： On
P108
Safety needle break starting
mechanical angle
20 0-359
P109
Safety needle break finished
mechanical angle
90 0-359
P110
Fixed stitches trimmer in
sewing and then bartack
selection switch
0 0-1
0： Off 1： On
P116 Single seaming function switch
0 0-1
0： Off 1： On
P123
Duty cycle of full opening
phase of the presser foot
100 0-100
P124 Starting condense stitch length
8 0 - 50
P125
Starting condense stitch
direction
0 0-1
0- forward stitch 1- reverse stitch
P126 Starting condense stitch speed
1000 100 - 2500
P127
Starting condense stitch needle
number
2 0 - 12
P128 Ending condense stitch needle
5 0 - 50
P129 Ending condense stitch speed
1000 100 - 2500
P130
Ending condense stitch needle
number
2 0 - 12
P131
Ending condense stitch needle
number
0 0 - 1
0- forward stitch 1- reverse stitch