Jackson Systems COMFORT SYSTEM Z-2000-T User Manual

SETTING THE MODBUS ADDRESS
Press the SETUP key again and the
LCD will display the Modbus
communications address. The factory
default is 01. The Z-2000-T has
integrated Modbus communications
capability for remote monitoring and
control. For more information on Modus
Communications, contact Jackson
Systems at 1-888-652-9663 or
info@jacksonsystems.com. (Figure 10)
TEMPERATURE CALIBRATION
OFFSET
Press the SETUP key again and the
LCD will display the temperature
calibration offset. The factory default
setting is 0. Typically, it is not necessary
to adjust the temperature calibration
offset as the Z-2000-T has been factory
calibrated. If calibration is necessary, a
high quality electronic digital
thermometer must be used. Place the
thermometer sensor probe next to the
thermostat sensor and allow five
minutes before comparing the
temperature readings. Use the UP and
DOWN keys to adjust the temperature
calibration. The range is +/- 9° F.
(Figure 11)
FIGURE 10
www.jacksonsystems.com
1.888.652.9663
8
FIGURE 11
SENSOR
LOCATION

Jackson Systems COMFORT SYSTEM Z-2000-T Specifications

General

Brand	Jackson Systems
Model	COMFORT SYSTEM Z-2000-T
Category	Thermostat
Language	English