CONTROLS 4
en-33
4.2.6.28 INHIBIT REGEN _________________________________________________________
Start the engine. Navigate to the Service Menu.
Use the UP and DOWN arrow keys until the green arrow is
next to Inhibit Regen. Press the select button to select Inhibit Regen.
Use the UP and DOWN arrow keys until the red arrow is next
to Enable or Disable. Press the select button to accept
When the Regen Inhibit is selected, the engine can not enter the Active or
Parked Regen states. Inhibit Regen does not prevent Passive Regen. If the
fuel tank is near empty, select the Inhibit Regen until the fuel tank has been
filled.
NOTICE
If the Regen cycle is prevented for too long of a period, a blockage of the
Diesel Particulate Filter (DPF) can occur. If a blockage of the DPF has
occurred, an authorized Kubota Engine Service Center must clean the
DPF before the mower is used.
Disable
Enable
Inhibit Regen
Fault Log
Time Until Service
Vehicle Status
I/O Diagnostics
Inhibit Regen
Parked Regen
Service Menu
To Next Page
Loading...
Need help?
General
