Pre-Delivery Checklist
Product No. 67827/67828 – LF-3810 Fairway Mower
Product No. _____________________ Serial No. ______________________
Tractor —————————————————
Check:
❏ Wheel lug torque:
❏ Front 80 - 100 ft. lb.
❏ Rear 40 - 45 ft. lb.
❏ Tire pressure should be:
❏ Front 10-12 psi (69-83 kPa)
❏ Rear 8-10 psi (55-69 kPa)
❏ Hydro linkage neutral centering adjustment (unit must not
creep in neutral)
❏ Traction pedal stop adjustment
❏ Parking brake adjustment
Engine —————————————————
Check:
❏ Engine oil level
❏ Engine coolant level
❏ Air cleaner element and connections
❏ Belt adjustments
Electrical System ————————————
Check:
❏ Interlock switch function
❏ Neutral start switch
❏ Parking brake switch
❏ Mower PTO switch
❏ Mower limit switch
❏ Seat switch / Time delay relay
❏ Operation of all function control switches
❏ 4WD cut-out switch (4WD only)
❏ Function of crosscut feature
❏ Dash panel gauges and warning lights
❏ For pinched or rubbing wires
Hydraulic System————————————
Check:
❏ Hydraulic oil level
❏ For pinched or rubbing hoses
❏ For twisted or crimped hoses
❏ For oil leaks
❏ Hydro tow valve is in ‘Drive’ position
❏ Backlap valves are fully closed
❏ Determine GreenSentry™ is operational
Cutting Units ——————————————
Check:
❏ Bedknife screws for tightness
❏ Reel for end play; there should be no free end play
❏ Roller bearing adjustment
❏ Reel drive belts adjustment
❏ All hardware properly tightened
❏ Adjust reel weight springs to give equal weight to all cutting
units. Caution: Check maximum safe exposed thread
length in the Parts & Maintenance Manual before making
this adjustment.
❏ Reel to bedknife clearance, .001” to .003” (.025 - .08 mm).
❏ Adjust cutting height to customers’ specs. (.025 - .08 mm)
Miscellaneous —————————————
❏ Check for loose or missing hardware
❏ All lubrication points
❏ Examine paint finish; touch up where necessary
❏ Check decals. In place and legible
❏ Make sure Manuals are in the pouch
❏ ______________________________________________
❏ ______________________________________________
Should you encounter any areas that required repair during set-up, please explain below and fax (414/635-1067) a copy of the
checklist and problem description to use.
Problem Description
______________________________________________________________________________________
________________________________________________________________________________________________________
________________________________________________________________________________________________________
________________________________________________________________________________________________________
Dealer ____________________________________________ Inspected by _______________________________________
Customer ____________________________________________ Date _____________________________________________