EasyManuals Logo

Jacobsen LF 570 Service Manual

Jacobsen LF 570
60 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #54 background imageLoading...
Page #54 background image
10 QUALITY OF CUT
54
10.4 STEP CUTTING ___________________________________________________________
NOTE: Arrow indicates direction of travel.
Step cutting occurs when grass is cut taller on one side of
a reel than the other or one cutting unit to another. This is
usually caused by mechanical wear or an incorrect roller
or HOC (height-of-cut) adjustment.
Probable Cause Remedy
HOC (height-of-cut) settings are different from one
side of a reel to the other or from one cutting unit to
another.
Check HOC adjustment of cutting units.
Worn front roller bearings. Check/replace front roller bearings.
Reel-to-bedknife contact is different from one side of
the cutting unit to the other or from one cutting unit to
another.
Check reel-to-bedknife contact.
Cutting reel movement is restricted. Check/remove cutting reel movement obstruction.
Variations in turf density. Change mowing direction.
Machine weight distribution is uneven. Check/adjust tire inflation pressure.
TN0221

Table of Contents

Other manuals for Jacobsen LF 570

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Jacobsen LF 570 and is the answer not in the manual?

Jacobsen LF 570 Specifications

General IconGeneral
BrandJacobsen
ModelLF 570
CategoryLawn Mower
LanguageEnglish

Related product manuals