Page 15
J-400 Series
Figure F
1. Obtain a at head screwdriver.
2. Place it ush against the middle slot of the
terminal block (diagram 1).
Figure G
1. Firmly press inward and upward
on screwdriver blade, then pivot
upward to open underlying wire
clamp. Hold this position for step 2.
2. Insert power wire into slot A as
shown, then remove screwdriver to
release terminal block clamp and
secure wire in place. Gently pull on
wire after installation to verify it is
clamped tightly into terminal.
Screwdriver Slots
1
2
1
A
Power wire Slots
Side View
Side View
To Next Page
Loading...
