Jacuzzi J-400 Series User Manual

Page 60
J-400 Series
13.2 Auto-Heating Mode
Auto-Heating mode is typically selected
by customers in cold climates where heat
up times are extended due to lower
ambient temperatures. In this mode,
water temperature is regulated by the set
temperature which activates the heater
automatically as needed.
Note: If you elect to use Auto-Heating, you can skip this
section. Auto-Heating is the default spa setting.
1. Press button B (Figure C) to enter the
Heating Menu. The menu appears
with Auto-Heating highlighted. If you
elect to use this mode, press the
Splash button on the Quad Keypad.
The display will conrm your
selection and Figure D will be
displayed.
2. To exit the submenu, press button D to return to the “Settings 2”
Menu.
13.3 Programmable Heating Mode
Programmable heating mode is typically selected by customers in warm
climates where heat up times are minimized due to higher ambient
temperatures. In this mode, the water temperature is regulated by the set
temperature only when a programmed heating cycle is running, unless in
summer logic page 64.
1. From the Heating Menu (Figure C), use the Quad keypad Down
button to highlight the programmable setting, then press the Splash
button to enable selection.
A. Program A Heating Mode
1. You are allowed to have two separate
programs in the programmable
mode, you can elect to use both or
just one. Press the Splash button to
enter the submenus for “Program A”
(Figure E).
HEATING
Auto-Heating
Press to set
Select
A
Programmable
Auto-Heating
Figure C
24-hour Heating
Enabled
Figure D
Figure E
PROGRAMMABLE
Program A
Press to set
Select
B
Program B
A
Program A
A

Jacuzzi J-400 Series Specifications

General

Brand	Jacuzzi
Model	J-400 Series
Category	Hot Tub
Language	English