HS-1RS User’s Manual Page 45
Code 128
Code 128 Defaults
Code 128 On/Off
Scan one of the codes below to enable or disable Code 128. Default = Enabled.
* Enable Disable
Code 128 Minimum and Maximum Length
Use the following commands in combination with numerical values to set the minimum
and maximum length. Default minimum length = 0. Default maximum length = 55.
The minimum and maximum length for this barcode can be set either by sending the serial
command shown under the barcodes below with a value between 0 and 55, or by building
a menu command barcode. Please contact JADAK if assistance is needed.
Code 128 Minimum Length Code 128 Maximum Length
ISBT 128 On/Off
ISBT 128 is a variant of Code 128 used in the blood bank industry. Scan the appropriate
bar code below to enable or disable ISBT 128. Default = Disabled
Enable * Disable
To Next Page
Loading...
