JWI-3000 6
Step 3: Install the Indicator (4) on the bracket,
with the bracket aligning with the bracket slot
(8) of the indicator.
Step 4: After connecting load cell connector to load cell port, the installation is completed.
Note: Use the knob pole (7) to adjust the inclination angle of indicator and the screw (6) to adjust
direction of the indicator. After adjusting the indicator to an optimal position, lock the screw.
5. Setting Mode
5-1 Maximum Weighing Capacity & Accuracy Setting
1. Press and hold key
ZERO/ESC
and
TARE/
while powering on the scale. When the
window displays “
300.00 KG
300.00 KG300.00 KG
300.00 KG”
,
release the key and it enter the capacity setting
2. Press
+/PRINT/HI
or
HOLD/LO/- to choose common used capacity.
Press
/G/N
or
TARE/
to shift the decimal point and press
UNIT
to choose kg, g, lb or
台斤
.
Note: if not the needed capacity, long press
UNIT/SET
until the number leftmost is blinking
to set the capacity casually. Please do as follows.
Press
/G/N
or
TARE/
to shift key leftward or rightward
Press
+/PRINT/HI
or
-/
HOLD/LO
to change the value.
Press
/G/N
or
TARE/
until the decimal point is blinking.
Press
+/PRINT/HI
or
-/
HOLD/LO
to shift the decimal point
Press
UNIT/SET
to choose kg, g, lb or
台斤
CAN DIEN TU TAN HIEP THANH
www.tanhiepthanh.com.vn
To Next Page
Loading...
Need help?
General
