98
EN EN
CONNECTING TO WIFI
Ensure your device is connected to a
wireless network, then open the JAM
WiFi app. On the home screen, press
"New Speaker Setup" to connect
the speaker. You will be prompted to
choose your speaker. Choose “JAM
Voice” from the speaker list. Please note:
only 2.4GHz networks are supported.
Power on your JAM Voice by
pressing and holding the power
button for 3 seconds. An
audible tone will indicate that
the unit is turned on, wait for a
second audible tone to indicate
your speaker is ready to
connect to you Wi-Fi network.
Have your wireless network
password ready. Press and
hold the button on the
bottom of your speaker for
3 seconds. After you do
this, you will hear an audible
confirmation: “Searching for
WiFi Connection.”
The app will prompt you to
enter your network password.
When connected, you will hear
“Connected,” the LED light on
the speaker will turn solid white,
and your app will show the
above screen.
Connect the speaker
to the power adapter
Plug the other end of the
power adapter into an
electrical outlet
Back Next
Back Next
Wait 60 Seconds for the
Jam speaker to boot
Once the light is solid
red, proceed to the
next step
Back Next
Press the Wifi Graphics
button on the back
of the speaker
Once in connection mode,
the blue light on top of the
speaker will start blinking
Please have your network password ready
Back Next
Press the Pair button on
the back of the speaker
Once in connection mode,
the blue light on top of the
speaker will start blinking
(Illustration goes here)
Please enter your Wifi Network Password
Cancel Confirm
Wifi Password
Streaming Service
FAVORITES
POP RADIO
INDIE RADIO
WORKOUT MIX
Connected.
How will you place
the speaker?
Done
Choose Your Speaker
Back
Bedroom
Office
Jam Voice
Speaker Settings + Info
Back
Rename Speaker
Equalizer Settings
Speaker Info
Sleep Timer
Firmware Update
Restore Factory Settings
Wifi Network Jones Home
Speaker Name Office
SSID Jam Home Audio_06D2
IP Address 192.168.1.117
Firmware Version 3.4.2820.145
Wi-Fi Strength
Language
Device Password
English
Speaker Info
Back
Firmware update available
Version 2.0.1
Download and Install
Firmware Update
Next
Amazon login successful
Skip Login
Next
Connected
Power on your speaker
by pressing and holding
the power button
for 3 seconds
Back Next
The LED light will flash
white when ready to pair
to your network.
Proceed to the next step.
Back Next
Press and hold the
button on the bottom of the
speaker for 3 seconds. Once in
connection mode, the speaker
will give you an audible
confirmation. Have your
network password ready.
Back Next
Jane Smith
Logout Back
Power on your speaker
by pressing and holding
the power button
for 3 seconds
Back Next
The LED light will flash
white when ready to pair
to your network.
Proceed to the next step.
Back Next
Press and hold the
button on the bottom of the
speaker for 3 seconds. Once in
connection mode, the speaker
will give you an audible
confirmation. Have your
network password ready.
Back Next
Jane Smith
Logout Back
Please select
your device
Jam Voice
Jam Rhythm
Jam Symphony