Jands Stage - Working with Grabs; Grab Faders 1 and 2; Grabbing a Scene

9
.
The Stage 12/24 has two (2) fully independent Grab controls.
The Grab Controls:-
Grab Faders 1 and 2
These Level faders control the output level of the Grab scene
ranging from 0 to 100%.
Grab Flash Buttons 1 and 2
These buttons correspond to the Grab faders and act in a similar
way to Preset flash buttons, but will flash the Grab'd scene to the
Add/Solo level.
Grabbing a Scene
• Decide which Grab fader is to be used to store the new scene.
• If the Grab LED to the left of the Grab fader is on, press the button to
clear the fader.
• Use the Preset faders, Flash buttons, Chaser, and the other Grab fader
outputs in any combination to generate the scene to be Grab'd.
• Press the Grab button to store the current output.
• The LED in the Grab button will illuminate to indicate there is a scene
stored in the Grab controls.
Working with Grabs