12
A 4 way DIP switch accessible through the rear panel enables the user to
change some of the operating parameters of the console. These are as
follows:-
#1 Use the STAGE as a slave console to an Event or ESP II
master console.
#2 Reverse the operation of the P2 master fader such that it is at
full when it is at the 0 position. This is used to enable single
action crossfades.
#3 Change the operation of the chase. See page 10.
#4 Single preset wide mode. The console operates as a single
preset console, with flash buttons on the first 24 channels.
(12 for Stage 12)
To change the console configuration, remove console power, change
switch positions as desired, and reapply power. Changes will be active
immediately.
Please note that when DIP switch #1 is on, all other switches are ignored.
When DIP switch #4 is on, DIP switch #2 is ignored.
Configuring the Console
To Next Page
Loading...
Need help?
General
