11
When DIP switch #3 is off, pressing the Go/Cue button alternately activates/
deactivates the Chase. When the chaser is not active, the LED in the switch
flashes at the chase step rate; when the chaser is active, the LED is on
continuously.
When DIP switch #3 is on, the chase is always active at the level of the
chase level fader. Additionally, the Go/Cue button is used as a chase flash
button, flashing the chase to the level of the Add/Solo fader when the button
is pressed. As with all other flash buttons, if the console is in Solo mode all
other output is removed when the chase Go/Cue button is pressed.
To Next Page
Loading...
