J&W X48 Series User Manual

- 28 -
Intel X48 Series User's Manual
4.5.5 Security Settings
This item allows you to Chage Supervisor/User Password, Type the password, up to
eight characters, and press <Enter>. The password typed now will clear any previously
entered password from CMOS memory. You will be asked toconrm the password. Type the
password again and press <Enter>.
Note: Don’t forget your password. If you forget the password, you will have to
open the computer case and clear all information in the CMOS before you can start
up the system. But by doing this, you will have to reset all previously set options.
BIOS SETUP UTILITY
Main Advanced
Boot
Security
Power
JUSTw00t!
Exit
Security Settings Install or Change the
password.
←
Select Screen
↑↓
Select Item
Enter Change
F1 General Help
F10 Save and Exit
ESC Exit
Supervisor Password :Not Installed
User Password :Not Installed
Change Supervisor Password
Change User Password
Boot Sector Virus Protection
Flash Write Protection
[Disabled]
[Enabled]
v02.61 (C)Copyright 1985-2006, American Megatrends, Inc.
►
Change Supervisor/User Password
►
Boot Sector Virus Protection
Uses this option, may prevent the change hard disk boot-sector (district table), thus
prevents the infection computer virus.
Optional: Disabled, Enabled
►
Flash Write Protection
This option is for BIOS protection function, selects disabled state, then it can update BIOS,
If the option is Enabled state, this is BIOS protection, then cannot ash write or ash
backup.

J&W X48 Series Specifications

General

Brand	J&W
Model	X48 Series
Category	Motherboard
Language	English