36
Loosen the integrated belts by pulling the straps (5b)
above the buckle while pressing the tightening button
(5c).
3
.b
Unfasten the buckle (5a).
3
.c
Place the child in the seat making sure that they are sit-
ting well back and that their back is straight. Join the top
ends of the buckle.
3
.d
Insert them into the central lock and press until you hear
them click.
3
.e
Pull the tightening strap (5b).
3
.f
Turn the seat to the position for travelling, you don’t
need to pull the lever.
3
.g
WARNING: The forward facing position is not re-
commended at all for babies of less than 76 cm
tall or under 15 months old.
The seat can be turned round 360°, the rotation only
locks in the two positions of use: rear facing and forward
facing.
To change the position of the seat:
Pull the lever (13) found on the side of the sear and pull
the seat towards you.
2
.a
Release the lever and turn the seat to the required po-
sition. It will lock when it reaches the position for trave-
lling.
2
.b
G. PLACING THE CHILD IN THE SEAT
The GRAVITY safety seat should preferably be installed
on the rear seat of the vehicle. Before installing the safe-
ty seat, make sure that the vehicle seat where you are
going to install it is i-Size, or that it is tted with ISOx
anchors and that your vehicle is on the list of compatible
vehicles.
To make it easier to place the child in the seat, you can
turn the seat so it faces the car door. The seat will not
lock in this position, once the child is in the seat the seat
should be turned back to the position for travelling.
Pull the lever (13) found on the side of the seat and turn
the seat.
3
.a
!
H. ADJUSTING THE INTEGRATED
STRAPS
The height of the shoulder straps should be adjusted
as the child grows. With the child sitting correctly in the
safety seat check the shoulder straps are at the right
To Next Page
Loading...
