JANE Gravity - Seat Maintenance and Cleaning Guide; Upholstery Cleaning and Refitting; Plastic Parts Cleaning Method

EN
38
The GRAVITY safety seat must be properly fastened
to your vehicle with the Isox anchors, even when it is
not in use, because in the event of an accident it could
get ung about and could injure the other occupants
of the car.
L. MAINTENANCE
Do not expose the upholstery to sunlight for long perio-
ds, when the seat is not in use, cover it or store it in the
boot.
Wash the plastic parts with soap and warm water, care-
fully drying all the components afterwards. The uphols-
tery can be removed for washing. Follow the instructions
below:
Headrest:
Remove the upholstery from around the headrest and
underneath the overhang of the headrest.
7
.a
Shoulder and crotch strap pads:
Undo the Velcro strips on the shoulder pads and take them
off the straps.The crotch strap pad is taken off over the
buckle.
7
.b
Upholstery on the seat part:
Unfasten the two side parts and take the cover off all
around the edges of the seat.
7
.c
Wash at a temperature never higher than 30º.
To t the upholstery back on, follow the same steps
in reverse.
IM 1894.02_GRAVITY.indd 38 20/10/16 10:03