Why does my Janome Sewing Machine needle thread keep breaking?
The needle thread might break because it is not threaded properly, the fabric is not being drawn to the back when sewing is finished, or the thread is either too heavy or too fine for the needle.
Why does the bobbin thread break on my Janome 108 Sewing Machine?
The bobbin thread may break because it is not threaded properly in the bobbin case, lint has collected in the bobbin case (clean the bobbin case), or the bobbin is damaged and doesn't turn smoothly (exchange bobbin).
Lists the names of the machine's components with corresponding numbers for identification.
Instructions on how to connect the sewing machine to an electrical power source.
Step-by-step guide on how to change the presser foot.
Instructions on how to safely remove and insert sewing machine needles.
Detailed instructions for threading the upper thread through the machine.
How to adjust needle and bobbin thread tension for balanced stitches.
Detailed steps for creating buttonholes on the sewing machine.
Identifies causes for a machine that runs poorly or makes noise.
Lists common reasons for the upper thread breaking during sewing.
Explains why the bobbin thread might break.
Common causes for the sewing needle breaking.
Troubleshooting steps for when stitches are skipped.
General| Type | Mechanical |
|---|---|
| Stitch Count | 8 |
| Maximum Stitch Width | 5mm |
| Maximum Stitch Length | 4mm |
| Buttonhole Type | 4-Step |
| Buttonhole Styles | 1 |
| Needle Threading | Manual |
| Bobbin Type | Front-loading |
| Weight | 11.5 lbs |
| Oscillating Hook | Yes |
| Needle Positions | 3 |
| Built-in Needle Threader | No |
| Free Arm | Yes |
| Presser Feet Included | Zipper Foot, Buttonhole Foot |
To Next Page
