23
Circuit board-A (1)
To remove:
1. Remove the front cover. (See pages 6 – 7)
2. Pull out connectors from the circuit board-A.
3. Remove the screws (6pcs.) and the circuit board-A.
To attach:
1. Follow the above procedures in reverse.
NOTE:
Do not disconnect the connectors by pulling on cord.
To disconnect, grasp the connector, not the cord.
Replacing the Electronic Components
Cirucit board-F connector
Setscrews
Cirucit board-A
Setscrews
Setscrews
Cirucit board-L connector
To Next Page
Loading...
