6
Changing External Parts
Front cover (1)
To remove:
1. Remove the face cover and free-arm cover (See page 4 and 5).
2. Remove the setscrews (A) q (2 pcs.).
3. Remove the setscrews (B) w (5 pcs.), back cover e.
4. Remove the setscrews (C) r (2 pcs.).
5. Disconnect all the connectors from the circuit board A.
NOTE:
Do not disconnect the connectors by pulling on cord.
To disconnect, grasp the connector, not the cord.
To attach:
6. Follow the above procedures in reverse.
q
w
w
w
r
r
e
To Next Page
Loading...
