Janome 2222 - Adjusting Bobbin Thread Tension; Pattern Selector Dial; Stitch Length Dial; Stitch Width Dial

www.toews.com
22
q
Pattern Selector Dial
Raise the needle and presser foot. Turn the
pattern selector dial to set the setting mark at
the symbol corresponding to the desired pattern.
q Setting mark
Note:
To avoid needle or fabric damage, make sure
the needle is up and out of the fabric while
selecting a stitch.
Turn the stitch length dial to set the setting mark
at the desired stitch length.
The higher the number, the longer the stitch
length
q Setting mark
• Adjust the dial in the 0.5–4 range when you
sew the zigzag stitch.
• Set the dial at “S.S.” to sew the stretch stitch
pattern sewing.
• If the stretch stitch pattern is uneven, turn
the stitch length dial in the direction of “–” to
compress it, or “+” to expand it.
Stitch Length Dial
S.S.
1
2
3
4
0
1
2
3
4
0
q
C
D
E
F
G
H
I
J
K
L
A
Adjusting Bobbin Thread Tension
For general sewing, the bobbin thread tension
does not need to adjust. However, you can adjust
the bobbin thread tension for a specific sewing
need.
Turn the adjusting screw to the right to tighten or,
to the left to loosen the tension.
1
2
4
3
5
0
q
Stitch Width Dial
Turn the stitch width dial to set the desired stitch
width at the setting mark .
The higher the number, the wider the stitch width
q Setting mark
Note:
Raise the needle above the fabric, when you
turn the stitch width dial.
Janome 2222 Instruction Manual
www.toews.com
2222 Owners Manual/ User Guide