Janome 2222 - Page 42

www.toews.com
36
b
n
m
,
.
!1
!2
!3
!4
b Depress the foot control to sew a
buttonhole.
The machine will sew the front bartack, left
row, back bartack and right row
automatically. Stop the machine at the
ending point.
!1 Ending point
n Raise the presser foot and cut the both
needle and bobbin threads leaving 10 cm
(4˝) thread ends.
Draw the needle thread to wrong side of the
fabric by pulling the bobbin thread.
Then, knot the threads.
m Remove the fabric and place a pin just
before the bartack at each end to prevent
cutting bartacks. Cut the opening with the
seam ripper.
!2 Pin
!3 Seam ripper
• To repeat buttonhole sewing
, To repeat buttonhole sewing, turn the stitch
selector to , then back to again, as
shown.
Now, simply step on the foot control to sew
an identical buttonhole.
. When the buttonhole sewing is finished,
push the buttonhole lever upward as far as
it will go.
!4 Buttonhole lever
• Adjusting buttonhole stitch density
Turn the stitch length dial to the right for a
coarser density.
Turn the stitch length dial to the left for a tighter
density.
C
D
E
F
G
H
I
J
K
L
A
C
D
E
F
G
H
I
J
K
L
A
1
2
3
4
0
Janome 2222 Instruction Manual
www.toews.com
2222 Owners Manual/ User Guide