Why is my Janome 3434D Sewing Machine skipping stitches?
If you're experiencing skipped stitches with your Janome Sewing Machine, there are a few things to check. The needle might be bent or blunt. Make sure the machine is threaded correctly. Also, verify that the needle is inserted correctly.
Why does the needle break on my Janome 3434D?
If the needle breaks on your Janome Sewing Machine, it could be due to a few reasons. The needle might be inserted incorrectly. It could also be bent or blunt. Avoid forcibly pulling the fabric; instead, pull it lightly.
Why does the thread keep breaking on my Janome Sewing Machine?
If the thread keeps breaking on your Janome Sewing Machine, several factors could be at play. It might be that the machine wasn't threaded correctly. Another possibility is that the needle or looper thread tension is too tight. Also, check if the needle is inserted incorrectly, or if it's bent or blunt.
What to do if the seam is not sewn neatly on my Janome 3434D?
If your Janome Sewing Machine is producing seams that aren't neat, it could be due to several reasons. The needle and/or looper thread tensions might not be adjusted correctly. Ensure the machine is threaded correctly. Also, the needle and/or thread may not be suitable for the fabric you're using. Finally, check that the thread is properly positioned between the tension discs.
What causes seam puckering on a Janome 3434D?
Seam puckering on your Janome Sewing Machine can occur if the needle or looper thread tension is too tight. Ensure that the machine is correctly threaded. Another cause may be that the differential feed dial is not correctly adjusted.
Why is the fabric not cut neatly by my Janome Sewing Machine?
If the fabric isn't being cut neatly by your Janome Sewing Machine, it could be because the position of the upper knife is not adjusted properly. Another reason may be that the upper knife is dull; in this case, replace it.
General| Type | Overlock |
|---|---|
| Number of Threads | 4 |
| Stitch Width | 5 mm |
| Stitch Length | 4 mm |
| Free Arm | Yes |
| Adjustable Cutting Width | Yes |
| Max Stitch Length | 4 mm |
| Max Stitch Width | 5 mm |
| Speed | 1300 stitches per minute |
| Presser Feet | Standard |
Warnings to prevent electric shock, including proper unplugging and water safety.
Safety guidelines to avoid burns, fire hazards, and personal injury during operation.
Step-by-step guide for threading the machine, including handling broken threads.
Specific instructions for threading the lower and upper loopers for proper stitch formation.
A guide to diagnose and resolve common problems encountered during sewing operations.
To Next Page
