6
CHANGING EXTERNAL PARTS
FRONT COVER
To remove:
1. Remove the face cover and free-arm cover (See page 4 and 5).
2. Remove the setscrews q (2 pcs.).
3. Remove the setscrews w (4 pcs.), back cover e.
4. Remove the setscrews r (2 pcs.).
5. Loosen the setscrew t.
6. Disengage the front cover and rear cover hooks.
7. Remove the front cover.
8. Disconnect all the connectors from the circuit board A.
NOTE:
Do not disconnect the connectors by pulling on cord. To disconnect, grasp the connector, not the cord.
To attach:
7. Follow the above procedures in reverse. See "PRINTED CIRCUIT BOARD A CONNECTION". (Page 24)
q
w
w
e
w
r
r
t
To Next Page
Loading...
