Janome 712T - Winding the Bobbin

9
q
i
e
r
q Turn the stop motion
knob counterclockwise to
disengage clutch.
r Insert the thread through the hole in
the bobbin from inside to outside as
shown.
t Put the bobbin on the bobbin winder
spindle, and push it to the right.
y While holding the free end of the
thread with your hand, pedal the
machine. Stop the machine when the
bobbin has made a few turns, and cut
the thread close to the hole in the
bobbin.
u Pedal the machine and wind the
thread until the bobbin stops. Move
the bobbin winder spindle to its
original position (left), and cut the
thread.
i Turn the stop motion knob clockwise
to engage clutch.
* The machine will not sew until the
stop motion knob is tightened.
Stop motion
knob
Bobbin winder
thread guide
w Draw the thread from the spool.
e Guide the thread around the bobbin winder thread guide.
•
Winding the Bobbin
t
y
u