10
q
w
e
q Place the bobbin in the
bobbin holder with the
thread end unwinding in the
clockwise direction.
w Guide the thread into the
notch “A” on the front side
of the bobbin holder.
Draw the thread to the left,
sliding it between the
tension spring blades.
r Close the slide plate.
Check the threading by
referring to the chart shown
on the slide plate.
e Continue to draw the
thread lightly until the
thread slips into notch “B”.
Pull out about 15 cm (6˝) of
thread.
•
Inserting the Bobbin
r
Threading chart
To Next Page
Loading...
