Why is the bobbin thread breaking on my Janome Magnolia 7312 Sewing Machine?
The bobbin thread may break because it is not threaded properly in the bobbin case. Also, lint may have collected in the bobbin case, so you should clean it. Finally, the bobbin itself might be damaged and not turning smoothly, in which case you should replace it.
Why does the needle break on my Janome Magnolia 7312 Sewing Machine?
The needle might be breaking because it is incorrectly inserted, bent, or blunt. The needle clamp screw could be loose, or the needle thread tension may be too tight. Also, the fabric may not be drawn to the back when sewing is finished, the needle could be too fine for the fabric, or the pattern selector dial may have been turned while the needle was in the material.
Why is my Janome Magnolia 7312 Sewing Machine not working?
The machine might not work because it is not plugged in, thread is caught in the hook race, or the stop motion knob is loosen for bobbin winding.
Why is the cloth not feeding smoothly through my Janome Sewing Machine?
If the cloth isn't feeding smoothly, the feed dog might be packed with lint. Alternatively, the stitches may be too fine, so try making them coarser.
Why is my Janome Magnolia 7312 noisy and not running smoothly?
The machine may not run smoothly and be noisy because threads have been caught in the hook mechanism, or the feed dog is packed with lint.
Why does the needle thread keep breaking on my Janome Sewing Machine?
The needle thread may be breaking due to several reasons: it might not be threaded properly, the tension could be too tight, the needle might be bent or blunt, or it could be incorrectly inserted. Also, check if the fabric is not being drawn back properly after sewing, or if the thread weight is unsuitable for the needle.
Key safety rules and practices for safe sewing machine operation.
Important warnings about potential hazards, user responsibility, and preventing machine damage.
Lists and identifies all major components and controls of the sewing machine.
Step-by-step guide to connecting the machine to the power supply and foot control.
Instructions on operating the foot control for speed and sewing control.
Adjusting needle thread tension for optimal stitch quality.
How to change the needle and check for damage or wear.
Comprehensive instructions for sewing zippers with the correct foot.
Step-by-step process for sewing standard buttonholes.
Addresses issues like needle thread breaking and tension problems.
General| Type | Mechanical |
|---|---|
| Number of Stitches | 12 |
| Maximum Stitch Width | 5mm |
| Maximum Stitch Length | 4mm |
| Free Arm | Yes |
| Presser Feet | Zipper, Buttonhole |
| Bobbin Type | Drop-in |
To Next Page
