Janome 7330 - Pattern selection mode; Stitch width adjusting mode; Stitch length adjusting mode; Presser Foot Pressure Adjusting Lever

14
7330
MECHANICAL ADJUSTMENT
BACKLASH (BETWEEN LOWER SHAFT GEAR AND SHUTTLE HOOK GEAR)
Jog the hook race back and forth to check rotary play.
The standard play should be 0.8 mm (0.03") or less when the hook point is within the feed dog wodth. If play
excess 0.8 mm, adjust as follows.
ADJUSTMENT:
1. Remove the bed cover (see page 5).
2. Loosen the setscrew.
3. Turn the lower shaft bushing (eccentric bushing) clockwise (B) if there is too much play in the shuttle hook.
Turn the lower shaft bushing (eccentric bushing) counterclockwise (A) if there is too little play in the shuttle
hook.
4. Tighten the setscrew securely after adjustment and install the bed cover.
NOTE:
After adjusting the backlash, be sure to check the needle to shuttle timing and the feed dog height.
Backlash allowance
Point of shuttle hook
Check the backlash
Groove
Groove on the lower
shaft bushing
Lower shaft gear
A
B
Setscrew
Shuttle hook gear