Janome 7330 - Altering the stitch length; Altering the needle drop position

32
7330
REPLACING THE ZIGZAG WIDTH MOTOR
TO REMOVE:
1. Remove the front and rear cover (see page 7 and 8).
2. Remove the two zigzag rod setscrews.
3. Remove the two setscrews and remove the zigzag width motor.
TO INSTALL:
4. To install the zigzag width motor, follow the above procedure in reverse.
NOTE
1. The setscrew of zigzag rod should be tightened to 5~7 kg of torque.
2. Check to ensure that the upper shaft sensor mounted on the zigzag width motor does not interfere with the
upper shaft shield plate.
3. Adjust the needle drop position (see page 13).
REPLACING THE ZIGZAG WIDTH MOTOR
2 setscrew (B)
Zigzag width setscrew (B)
Setscrew (C)
Setscrew (C)
Zigzag width motor
Zigzag width motor