Janome 9102D - Machine Care and Maintenance; Knife and Light Bulb Replacement

72
PIN TUCKING
*
Refer to page 62 (Narrow Hemming) for thread
tension balance adjustment.
1 Pin tucking
Thread and Fabric
Fabric
Light to
Medium
Fabric
Needle thread on the
right
Upper looper thread
Lower looper thread
Synthetic : No. 60~80
Silk : No. 50~80
Synthetic : No. 60~100
Silk : No. 50~100
Thread
Machine Setting
1 Remove the needle on the left-hand side
2 Needle plate setting knob : R
3 Upper knife : Down
Sewing
Turn off the power switch.
Remove the needle on the left-hand side.
Deactivate the upper knife.
Turn on the power switch, then sew the folded edge
while guiding along the guide line.
1
Folded edge
2 Guide line on the needle plate
3 Right needle position line on the presser foot
4 Left needle position line on the presser foot
5 Right side of fabric
Open the fold flat and press the pin tucks to one side.
NOTE: After you finish sewing,return the upper knife
to rhe original position.
HA-1 SP No.11 or No.14
1
2
2
1
3
1
3
4
5
6
6 Pin tucking