Janome DC4030P - REPLACING THE FUSES

26
DC4030P
Setscrews (4)
Printed circuit board "A"
Printed circuit board "A" case
REPLACING THE FUSES
Fuse holder
Fuse
F2. AC250V 2.5A
F1 AC250V 3.15A
F3. AC250V 2.5A
FUSE NO.
F2, F3
F1
PART NO.
000-144-605
000-182-904
REPLACING THE FUSES
TO REMOVE:
1. Remove the front cover (see page 4).
2. Remove the four setscrews and remove the cover on printed circuit board "A".
3. Remove the fuse (pry it out with a screwdriver).
TO INSTALL:
4. Follow the above procedure in reverse.
NOTE
1. Replace the printed circuit board "A" if you notice any browning, discoloration, or other
abnormalities.
2. Only install fuses with the correct rating.
3. If the fuse is loose, bend the fuse holder inward to secure the fuse.
5.2 X 20 MM 2.5 A TIME-LAG FUSE
5.2 X 20 MM 3.15A TIME-RUG FUSE
TYPE/SPECIFICATION
TSD-2.5A-250V
3.15A-250V