MECHANICAL ADJUSTMENT
STRAIGHT STITCHING
TO CHECK:
1. Set the stitch width dial at “0” and the stitch selector at stitch No. 3 (Simple
zigzag).
2. Turn the hand wheel by hand.
3. The needle should not swing side to side at this setting.
ADJUSTMENT PROCEDURE:
1. Remove the top cover (See page 4).
2. Loosen screw (A).
3. Move the zigzag width rod (B) until the needle ceases its zigzag movement when
you turn the hand wheel toward you.
4. Tighten screw (A) firmly.
10
To Next Page
Loading...
