SERVICE ACCESS
FACE COVER
1. Open the face cover (A).
2. Remove the screws (B).
3. Take the face cover (A) off.
TOP COVER
(TO REMOVE)
1. Remove screws (C) and (D).
2. Raise the carrying handle (E), lift the top cover (F), and separate the carrying
handle stays (G) from each pin (H) by pushing them from both sides.
3. Detach the top cover together with the carrying handle.
(TO ATTACH)
4. Put the top cover and carrying handle together, and fit the carrying handle stays to
each pin while pushing them from both sides.
5. Attach the top cover with the set screws (C) and (D).
(There should no interference with the pressure dial and the clearance between
the front panel and top cover should be uniform.)
4
To Next Page
Loading...
