www.janome.com
Join us!
Memory Craft 15000
Horizon Memory Craft 15000
desired speed. Close to the end of the seam, Press and Hold the start button: the machine will slow down and when
the end of the fabric is under the needle release the button and the machine will stop.
b. Select Stitch 9 zigzag.
• The width and length are displayed at the bottom of the touch screen.
• Sew a zigzag stitch and adjust stitch width. The stitch automatically
made a four stitch lock at the beginning. Press the locking stitch button
at the end so that the machine will lock and stop. If the Thread Cut after Auto-Lock has been
turned on the machine will also cut the thread and lift the foot.
• DFT returns all settings to the Default.
• Touch the cloth guide icon. Touch OK at the pop up window. Attach the cloth guide, touch OK and the guide will
automatically move to the 5/8” position, move the guide to the left so screen shows ½”. The cloth guide can be set
anywhere from 1/16 of an inch to the left of center needle position to 8” to the right. Touch OK. Select the straight
stitch #1. Place the fabric edge along the guide and sew a short seam.
• Touch the ClothGuide icon; touch the ClothGuide Storage button , to return the carriage to the home position.
• Touch the AutoPivot button.
• Fold a 6” square of cotton in half and sew a short seam and stop, the foot will automatically lift for pivoting. This will
remain on until the machine is set for the embroidery mode or turned off.
4. Sewing Applications
a. Touch Home . Sewing Applications . This is an easy way to find common functions of the machine as well
as some exclusive features.
• Seaming
• Overedge
• Blind hem
• Shell tuck
To Next Page
Loading...
