Janome HT2008 - Round End and Keyhole Buttonholes; Machine Setup and Sewing Sequence; Adjusting Buttonhole Width

www.toews.com
52
Round end/Keyhole buttonhole
Machine setting
q Pattern or
w LED display
e Foot R: Automatic buttonhole foot
qw e
q
q
w
w
q
w
qw
Adjusting the buttonhole width
Press the mode selection key to enter the stitch
width adjusting mode.
Press the Down (–) key to decrease buttonhole width.
Press the Up (+) key to increase buttonhole width.
The width of round end buttonhole can be varied
from 2.5 to 5.5.
q Narrow buttonhole (2.5mm wide)
w Wide buttonhole (5.5mm wide)
The width of keyhole buttonhole can be varied from
5.0 to 7.0.
q Narrow buttonhole (5.0mm wide)
w Wide buttonhole (7.0mm wide)
Refer to page 50 for stitch density adjustment.
The sewing sequence is the same as square
buttonhole .
Refer to pages 44-48 for sewing instruction.
q Starting point
w End point
Janome HT2008 Instruction Manual
Janome 2008 Sewing Machine
www.toews.com
HT2008 Owners Manual/ User Guide