9
WITH THE BLOCK (A)
REMOVED, THE
PRESSER FOOT WILL
BE LOWERED
NEEDLE PLATE
6.6 mm
6.0 mm
WASHER
NO GAP
GAP
BLOCK (A)
PRESSER FOOT
LIFTER
SETSCREW (H)
PRESSER BAR
SUPPORTER
PRESSER BAR HEIGHT AND ALIGNMENT (2)
8 PLACE THE BLOCK (A) (6.6 mm) BETWEEN THE
PRESSER FOOT AND NEEDLE PLATE.
(THE PRESSER FOOT LIFTER SHOULD BE AT
THE NORMAL UP POSITION)
9 LOOSEN THE SETSCREW (H) ON THE PRESSER
BAR SUPPORTER WHILE THE PRESSER FOOT
HOLDING THE BLOCK (A).
MAKE SURE THERE SHOULD BE NO GAP
BETWEEN THE WASHER AND THE PRESSER BAR.
TIGHTEN THE SETSCREW (H).
WHEN REMOVING THE BLOCK (A), THE DISTANCE
BETWEEN THE SURFACE OF THE NEEDLE PLATE
AND THE BOTTOM OF THE ZIGZAG FOOT SHOULD
BE 6 mm.
NORMAL UP
POSITION
MECHANICAL ADJUSTMENT
To Next Page
Loading...
