Janome MC9900 - Switching Power Supply Unit

11
MC 9900
⁄6 The Y-motor @1 is separated from the base @2.
⁄7 Remove the setscrews @3 (2 pcs.).
⁄8 Remove the cord binder and disconnect the
connector @5 from the printed circuit board S2 @4.
⁄9 Pry up the lock tab of the connector with a precision
driver and pull out the red @6, orange @7, brown @8,
brown @9 and red #0 cords.
Remove the Y-motor.
•AttachingY-motor
Follow the above procedure in reverse.
@1
@2
@3
@4
@5
@6@7@8@9#0
NOTE:
The colors of the cords may differ from actual
products.
@3