18
MC 9900
Replacing Y-belt
•
Removing Y-belt
z Remove the hexagonal socket screw q.
Slide the stopper in the direction of arrow.
x Remove the setscrews w.
c Remove the setscrews e.
v Remove the Y-belt.
•AttachingY-belt
b Attach the Y-belt.
r
n Be sure that the Y-belt deflection to about 3 mm by
pressing the middle of Y-belt with approximately 30
grams of pressure.
If not, turn the Y-carriage upside down.
Loosen the nut r, and turn the eccentric pin to adjust
the belt tension, then tighten the nut.
m Follow the “removing Y-belt” procedure in reverse.
q
w
w
w
w
e
e
To Next Page
Loading...
