16
Built-in Needle Threader
1 Raise the needle to its highest position by pressing
the Up/Down Needle Button twice.
2
Turn the Power Switch OFF.
3 Lower the presser foot.
4 Depress the Needle Threader Knob as far as it will
go. The hook comes out through the needle eye
from behind.
1 Up/Down Needle Button
2 Needle Threader Knob
3 Hook
5 Draw the thread down around the Threader Guide
and under the hook.
4 Threader Guide
6 Release the threader knob slowly while holding the
thread end with your hand. A loop of the thread is
pulled up through the needle eye.
7 Remove the loop from the threader and pull out the
thread end from the needle eye.
NOTES:
The automatic threader works well with the threads
#50-90 and needles #11-16, the blue tipped needle as
well.
1
4
5
6
1
7
2
3
2
3
4
3
To Next Page
Loading...
