42
Applique
q Stitch pattern: 23
w Thread tension dial: 1 to 4
e Presser foot: Satin stitch foot F
* The stitch patterns 24 and 25 can also be used.
Place an applique on the fabric and baste or pin it in place.
Lower the needle at the outer edge of the applique.
Sew while guiding the fabric so the needle falls along the
outer edge of the applique.
q Applique
w Outer edge
When turning a sharp corner, stop the machine with the
needle at the outer edge of the applique (refer to page 12).
Raise the foot and pivot the fabric around the needle to
change the sewing direction.
• Adjusting the stitch width
Select pattern .
Press the mode key e until the cursor r appears under
the stitch width value.
Press the “–” sign on the value set key t to decrease the
stitch width u.
Press the “+” sign on the value set key t to increase the
stitch width i.
e Mode key
r Cursor
t Value set key
The stitch width will be varied based on the centered
needle drop position y.
(A) The stitch pattern 23 has a xed center needle drop
position. The stitch width changes symmetrically.
(B) The stitch patterns 24 and 25 have a xed right needle
drop position. When you change the stitch width, the left
needle drop position will change.
q
w
e
q
w
(A) (B)
u
i
y
r
t
e
To Next Page
Loading...
