54
4, 5. Slide the thread from the bottom of front cover
thread guide (2) and the take-up lever cover
right to left.
6. Guide the thread over the front cover thread guide
(3).
7. Insert the thread into the left slot of the needle
thread guide plate.
8. Raise the needle to its highest point and pass the
thread through the needle bar thread guide from
left to right.
9. Thread the left needle from front to back and pull
the thread about 10 cm (4˝) from the eye of the
needle to the back under the foot.
r
Front cover thread guide (2)
t Take-up lever cover
y Front cover thread guide (3)
u Needle thread guide plate
i Needle bar thread guide
o Left needle
* You can easily thread the machine if you use the
Needle Threader included in the standard
accessory. (See page 50)
r
u
t
i
y
o
r
t
y
4, 5, 6, 7, 8, 9
To Next Page
Loading...
