Janome My Lock 744D - Care of Your Machine; Replacing the Upper Knife; Cleaning Upper Knife Area

86
PIN TUCKING
* Refer to page 77 (Narrow Hemming) for thread
tension balance adjustment.
q Pin tucking
Thread and Fabric
Fabric
Light to
Medium
Fabric
Needle thread on the
right
Upper looper thread
Lower looper thread
Synthetic : No. 60~80
Silk : No. 50~80
Synthetic : No. 60~100
Silk : No. 50~100
Thread
Machine Setting
q Remove the needle on the left-hand side
w Needle plate setting knob: R
e Upper knife: Down
r Lower looper pre-tension setting slider: STD
t Changeable thread guide: 3/4
Sewing
Turn off the power switch.
Remove the needle on the
left-hand side.
Deactivate the upper knife.
Turn on the power switch, then sew the folded edge
while guiding along the guide line.
q
Folded edge
w Guide line on the needle plate
e Right needle position line on the presser foot
r Left needle position line on the presser foot
t Right side of fabric
Open the fold flat and press the pin tucks to one
side.
Note: After you finish sewing, return the upper knife
to the original position.
y Pin tucking
HA-4 SP No.11
or NO.14
t
q
w
e
r
t
q
w
e
r
y
q
3/4
2