Need help?Do you have a question about the Janome MyLock 434D and is the answer not in the manual?
General| Type | Overlock |
|---|---|
| Number of Threads | 3 or 4 |
| Differential Feed | Yes |
| Speed | 1, 300 stitches per minute |
| Needles | 2 |
| Presser Foot | Snap-on |
| Stitch Options | rolled hem |
| Stitch Width | 5 mm |
| Stitch Length | 1.0 - 4.0 mm |
| Cutting Width | 5.7 mm |
| Threading | Color-coded threading |
| Differential Feed Ratio | 0.7 to 2.0 |
Identifies the various components of the sewing machine with labels.
Connects the machine to power and explains speed control.
How to turn the balance wheel and operate machine covers.
Positioning the thread guide bar and setting up the spool stand.
Attaching accessories and operating the presser foot.
Step-by-step guide for threading the lower looper.
Instructions for threading the upper looper.
Detailed steps for threading the right needle.
Detailed steps for threading the left needle.
Instructions for threading the machine for 3-thread serging.
Instructions for starting, finishing, using guide lines, and continuous sewing.
Details on adjusting thread tensions and using the dial.
Steps for adjusting thread tensions and using the dial for 3-thread setups.
How to adjust stitch length and differential feed ratio.
Steps for changing the needle and adjusting foot pressure.
Operating the presser foot and upper knife.
Recommended settings for rolled hemming, picot edging, and narrow hemming.
Settings for decorative overedging and gathering.
Settings and steps for performing pin tucking.
Instructions for replacing and cleaning the upper knife.
Steps for replacing the light bulb and cleaning the feed dog.
To Next Page