3. Control panel and functions
3.1 Overview of welding mode panel
The operation interface is divided into four parts, including Homepage, Technology, Settings, and
Monitoring.
3.1.1 Home interface of touch screen
Figure 3-1 Home interface of welding mode
1) This interface shows the current technical parameters (which cannot be modified in this interface)
and real-time alarm information.
2) When the enable is turned off, no enable signal will be sent to the laser, which can be used to test the
gas outlet function. Turn off the red light indication and the motor stops working. At this point, the red
light is a point, which is used to adjust the center position. Welding modes are divided into continuous
welding and spot welding. When selecting spot welding, you need to set the spot welding type on the
settings page.
3) The safety ground lock comes in grey and green. When the metal clip is clamped on the workpiece
and the brass nozzle of the torch body contacts the workpiece, Pins 5 and 6 of the signal interface 1
To Next Page
Loading...
