are connected and the safety ground lock indicator light is green. At this point, press the laser enable
button on the panel and then press the trigger to achieve light emission.
4) Click the in the upper right corner to switch between cleaning modes
5) is the light emission indicator icon, which is white when no light is emitted. When the laser
emission is normal, the icon turns orange
6) Set the scanning width to 0 and replace the brass nozzle for cutting to perform cutting operations.
The cutting control logic is the same as welding, and press the trigger while connecting the safety
ground lock.
3.1.2 Technology interface
Figure 3-2 Technical interface of welding mode
1) The technology interface contains the debugging technology parameters, which can be modified by
clicking the box; after modification, click OK to save it in the quick technology; and click Import to
To Next Page
Loading...
