import the technology for use (Modify - Save - Import).
2) The scanning speed range is 2-6000mm/S and the scanning width range is 0~6mm. The scanning
speed is limited by the scanning width, and their relationship is: 10 ≤ scanning speed/(scanning
width*2) ≤ 1000. If the limit is exceeded, it will automatically change to the limit value. When the
scanning width is set to 0, the machine does not scan (i.e., point source) (most common scanning
speed: 300 mm/S, width: 2.5 -4mm).
3) The peak power needs to be less than or equal to the laser power on the parameter page. For
example, if the laser power is 1000W, this value shall be not higher than 1000.
4) The duty cycle range is 0~100 (100 by default, usually no changes are needed).
5) The suggested pulse frequency range is 5-5000Hz (2000 by default, which is often not changed.)
6) Click the HELP button on the top right to get more description of relevant parameters.
7) After modifying the parameters, you can check whether the import is successful on the homepage.
To Next Page
Loading...
