Figure 3-4 Welding time sequence
4) Wire feed delay compensation, i.e., the wire feed advance time relative to the light emitting signal,
can be used in conjunction with the withdrawal function.
5) The maximum threshold value of the temperature alarm is 70℃. When the value is set to 0, no
temperature alarm is detected.
6) Scan correction coefficient=target line width/measurement line width, which is within a range of 0.01 -
4. Generally set to 1.
7) The laser center offset is -3~3 mm, decreasing to the left, increasing to the right.
8) The spot welding duration is the light emission time when the trigger is pressed. Even if the trigger is
released, the light will still be emitted according to the emission time.
9) The spot welding interval time is the light stopping time between two spot welds after the trigger is
pressed.
10) The alarm level signal is set by default, masking alarm can directly change to the corresponding level
detection.
11) Click the HELP button on the top right to get more description of relevant parameters.
To Next Page
Loading...
