3.4 Description of wire feeder control panel
Figure 3-9 Wire feeder panel diagram
Table 3-2 Description of wire feeder panel functions
Continuous and
pulse modes
Click the button to switch between "Continuous mode" and "Pulse mode".
In "Continuous mode", the pulse time and interval time are disabled and the
corresponding parameters cannot be adjusted;
In "Pulse mode", the pulse time, interval time, and parameters can be adjusted.
Controls the wire feed speed during welding. The range is 25-600 cm/min and can
be directly adjusted through the panel knob.
Controls the manual wire feed speed. It is generally used for daily debugging of the
machine. Continuously press the "Manual wire feed" button and the motor will
continue to feed the wire at the fastest speed. Release the button and the machine
will stop feeding.
Controls the manual withdraw speed. It is generally used for daily debugging of the
machine. Continuously press the "Manual withdrawal" button, and the motor will
continue to withdraw the wire at the fastest speed. Release the button and the
machine will stop withdrawal.
Controls the wire feeder to switch the working state. Click "Stop" and the panel will
display "——". At this point, the machine is in "Stop" state and the motor cannot feed
or withdraw the wire. Click "Run" and the panel will display the set wire feeding
speed. At this point, the machine is in "Run" state and the motor can feed the wire
To Next Page
Loading...
