3.5 Description of wire feeder rear panel components
Power switch: controls the power input of the wire feeder.
Control cable: Connected to the machine so that it can provide power and welding torch signals to the
wire feeder.
4. Installation
4.1 Installation requirements
4.1.1 Installation environment requirements
Read the following precautions when selecting an installation environment.
Avoid installing the machine in an environment where there is dust or metal powder;
Avoid installing the machine in an environment where there is corrosive or explosive gas;
Ensure that the working environment is at a temperature between -10°C and 40°C. If it is used in an
environment with a temperature lower than 7℃, antifreeze should be used to protect the coolant from
being frozen;
The machine should be used in an environment of humidity lower than 90% without any
condensation water droplets;
The altitude shall be no more than 1000m;
The inclination of machine should not exceed 10°. When the machine is placed on a slope, additional
fixing measures should be taken to prevent the machine from sliding;
There is no obvious vibration or impact;
Please consult and confirm with JASIC's customer-service personnel first for any special erection
requirements.
4.1.2 Installation space requirements
The laser welder shall be at least 30 cm away from walls or other objects.
4.2 Electrical connection
Precautions:
To Next Page
Loading...
