CONFIGURATION AND CALIBRATION – Software Calib.
Page 68 of 80
Indicator gain adjustments are made on each of the SCP circuit boards
contained in each station MCP.
RAI Adjustments
FFU Input 1 ROI Adjustments
Digital Helm ROI Adjustments
With PORT selected from the drop down list an LED will be on beside
three of the six indicator trimmers. Adjust the trimmer indicated by the
LED for each of the indicator types used in order to ensure that the
indicator displays the correct hard over angle. After the port adjustment
has been made, select STBD from the drop down list and repeat the
adjustment for each indicator type used. With STBD selected the opposite
three LED’s will be lit to indicate which trimmers to adjust.
Doc No.: MAN01504, 20-02-06 DSC 100 & MCP 100 Manual
To Next Page
Loading...