DONT'S
Don’t force elevating crank up or down.
Don’t rotate directional handle hard against stops.
Don’t travel with lift in up position.
Don’t leave lift part way up or down.
Don’t apply sealing compound or paint over top of base plate or anywhere on lift.
Lubricating the antenna
The elevating gear should be lubricated 3-4 times a year with silicone spray.
Two times yearly or in the event rotating the antenna becomes difficult, normal operation
can be restored by lubricating the bearing surface between the rotating gear housing and
the base plate. Any silicone lubricant spray may be used.
Lubricate rubber quad ring on elevating shaft which is below worm gear with silicone
spray lubricant at least twice yearly. This will keep quad ring from becoming brittle which
could result in leaks down elevating shaft.
Refer to the manufacturer’s user guide for detailed information on lubricating the antenna.
TELEVISION POWER SUPPLY (IF SO EQUIPPED)
For good station reception, the TV power supply must be turned ON to
view local television stations. Turning the TV power supply ON sends
12-volt DC through the cable to the TV roof antenna. The voltage
energizes the transistors in the antenna head amplifier. The TV signal
then comes down the cable to the outlets.
Turn the TV power supply OFF to view cable television or to use a VCR
or DVD.
To Next Page
Loading...
Need help?
General
